• 802.11 b/g/n Micro Mini Wireless LAN USB2.0 Adapter User’s Manual. • Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. • Supplement C. This equipment should be installed and operated with minimum distance 2.5cm between the radiator & your body. CE Statement: Hereby, AboCom, declares that this device is in compliance with the essential requirement and other relevant provisions of the R&TTE Driective 1999/5/EC.

Distance 2.5cm between the radiator & your body. Install the Software. When you are prompted the following message, please click Install to begin.

• Table of Contents INTRODUCTION.1.1 EATURES Windows 2000/XP Installation.2.2 NSTALL THE OFTWARE.5 NSTALL THE ARDWARE Windows Vista Installation.6.6 NSTALL THE OFTWARE.8 NSTALL THE ARDWARE.8 ERIFICATION NETWORK CONNECTION.9 IP A.9 DDRESS UTILITY CONFIGURATION FOR WINDOWS 2000/XP.10.11 TATION Profile.11. • WPS.30 Radio On/Off.33 About.34.35 TILITY.36 MODE Config.36 Access Control.39 MAC Table.40 Event Log.41 Statistics.42 About.43 UTILITY CONFIGURATION FOR WINDOWS VISTA.44.45 TATION Profile.45 Network.53 Link Status.57 Advanced.59 Statistics.60 WMM / QoS.62 WPS.63 Radio On/Off.66 About.67. •.68 MODE Config.68 Access Control.71 MAC Table.72 Event Log.73 Statistics.74 About.75 UNINSTALLATION FOR WINDOWS 2000/XP.76 UNINSTALLATION FOR WINDOWS VISTA.78. • The WU5205 is an IEEE802.11b/g/n USB adapter that connects your notebook to a wireless local area.

The WU5205 fully complies with IEEE 802.11n draft 3.0 and IEEE 802.11 b/g standards, delivers reliable, cost-effective, feature rich wireless connectivity at high throughput from an extended distance. • Install the Software Caution Do not insert the wireless card into your computer until the InstallShield Wizard finish installing. Exit all Windows programs. Insert the included CD-ROM into your computer. The CD-ROM will run automatically. When the License Agreement screen appears, please read the contents and select “I accept the terms of the license agreement “.

Select the check box to choose a Configuration Tool from the listed two choices. Raspolozhenie ordenov medalej na paradnom kitele armii rf. Configuration Tool: Choose to use our configuration utility.

Microsoft Zero Configuration Tool: Choose to use Windows XP’s built-in Zero Configuration Utility (ZCU). Click Next to continue. When the following screen appears, click Finish to complete the software installation. • Install the Hardware Note: Insert the Wireless USB card when you finished your software installation. Insert the USB Adapter into the USB Port of your computer.

The system will automatically detect the new hardware. • Install the Software Do not insert the wireless LAN adapter into your computer until the procedures in “Driver& Utility Installation” have been performed. Insert the included CD-ROM into the CD-ROM drive of your computer.

When the Main Menu screen appears, click “Driver & Utility Installation”. • When you are prompted the following message, please click Install to begin the installation.

When the following screen appears, click Finish to complete the software installation. • Install the Hardware Note: Insert the Wireless USB card when you finished your software installation. Insert the USB Adapter into the USB Port of your computer. The system will automatically detect the new hardware. Verification To verify if the device exists in your computer and is enabled, go to Start > Control Panel. • IP Address Note: When assigning IP Addresses to the computers on the network, remember to have the IP address for each computer set on the same subnet mask.

If your Broadband Router use DHCP technology, however, it won’t be necessary for you to assign Static IP Address for your computer. • UTILITY CONFIGURATION FOR WINDOWS 2000/XP After the Wireless adapter has been successfully installed, users can use the included Configuration Utility to set their preference. Go to Start (All) Program Intelligent Wireless Intelligent Wireless Utility. You can also open the Configuration Utility by double clicking the icon or right clicking to select Launch Config Utility. • Station Mode Notice: Under screen resolution 800 x 600 pixels, click the triangle button at the right down corner of the utility to expand the information of the station, the information will not be displayed completely. Profile Profile can book keeping your favorite wireless setting among your home, office, and other public hot-spot.

• Network Type Shows the network type of the device, including Infrastructure and Ad-Hoc. Authentication Shows the authentication mode.

Encryption Shows the encryption type. Use 802.1x Whether or not use 802.1x feature.

Tx Power Transmit power, the amount of power used by a radio transceiver to send the signal out. • SSID: The SSID is the unique name shared among all points in your wireless network. The name must be identical for all devices and points attempting to connect to the same network.